Lift Truck Cage Simple fixtures, like this safety backstop for an electric hi-low are assembled by one person reading blueprints out on the shop floor.  Before the fixture is taken apart, a digital picture is taken to be stored away for future reference should the fixture have to be rebuilt at a later date.  Once the part is welded, the fixturing is disassembled and reused for the next job in the schedule.

Fixture Highlights

• Stop bars on the side of the table swing down to remove part when done
  
  
• Laser cut center section is clamped securely to table with standard clamps
  
  
• Sides of frame are clamped with spring loaded plunger bars
  
  
• Parts can be located directly on table surface or raised up with spacers