Loader Arms Lifting arms for a wheeled loader are welded on a 3-dimensional 5’ x 10’ modular weld table.  The four machined sides of the table have the same hole pattern as the table top (100 x 100mm grid with 50mm offset bores) which provides locating positions for stop bars, edge stops, adjustable angles, outriggers, consoles, clamp bars, etc.

Fixture Highlights

• Stop bars locate the inner gussets and then swing out to remove part
  
  
• Side and end of the table are used to create a perfect 90 degree corner
  
  
• Small black angles both locate side of part and provide a hole for a clamp
  
  
• Spacer post with various spacer rings used to fine tune final datum points